Classic Hotsell Stand Alone Smoke Alarm KD-133A

KD-135A/B/C/D/E Optical smoke alarm

15

1134

1134-CPR-101

EN 14604:2005/AC:2008 

KD-135DoP001

The instruction of smoke alarm devices

Introduction

Ⅰ.  Technical parameter

Working Voltage：DC9V

Current：Quiescent Current：≤10uA

Alarming Current: ≤ 20mA

Alarming Decibel：≥85dB/3m

Low voltage Alarming：≤7.3V

Working Temperature： -10℃~+40℃

Working Humidity：≤95%RH

CAUTION!

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type.

Test the alarm for correct operation using the test facility, whenever the battery is replaced.

Ⅱ、Dimension（mm）

Ⅲ、Test

Note：If the battery installed in wrong way, the detector will not work and maybe destroyed. If the detector operates smoothly, the Red LED will flash once in about 43S.

1、Contrarotate the installation panel in order to remove it;

2、Remove the insulated material and make sure the battery is connected in correct way;

3、Adjust the clips of the installation panel to the notches of the detector and turn the smoke detector clockwise in order to fasten it;

4、Depress the test button，the RED LED flashes quickly and in the mean while the detector sounds, it means the the detector works well.

Ⅳ、Installation

1、Choose a good position to instal the smoke alarm（ceiling）

2、Use the screw to fix the installation panel onto the ceiling.

3、Turn the smoke detector clockwise in order to fasten it to the installation panel tightly.